您好,欢迎来到中国测试科技资讯平台!

首页> 《中国测试》期刊 >本期导读>变频电量校准系统设计

变频电量校准系统设计

2033    2020-05-27

免费

全文售价

作者:柏文琦1,2, 吴双双1,2, 李银轩1,2

作者单位:1. 湖南省计量检测研究院, 湖南 长沙 410014;
2. 国家变频电量测量仪器计量站, 湖南 长沙 410014


关键词:变频电量;标准源;校准系统


摘要:

针对高电压、大电流电量测量变送器及分析仪量值溯源的难点问题,该文采用虚功率方法设计一种高电压、大电流宽频功率标准源及测试系统。首先给出变频功率标准源总体方案,以及变频电量溯源技术方案;设计一种基于磁调制原理的大电流测量精密交直流I/V转换器和基于电阻串并联分压原理的精密交直流V/V转换器;利用LabVIEW和数据采集卡PCI-5922,开发变频电量测试系统。在频率分别为100,200,400,600,800,1 000 Hz情况下,对I/V转换器(量程为100,200,500 A)和V/V转换器(量程为100 ,200,1 000 V等)的幅值和相移分别做比对实验。测试结果表明:I/V转换器幅值最大误差小于0.02%,V/V转换器幅值最大误差小于0.02%,证实系统设计的准确性和实用性。


Design of frequency conversion electricity calibration system
BAI Wenqi1,2, WU Shuangshuang1,2, LI Yinxuan1,2
1. Hunan Institute of Metrology and Test, Changsha 410014, China;
2. National Variable Frequency Electricity Metrology Station, Changsha 410014, China
Abstract: A standard power source with the high voltage and the large current and its measuring system based on the virtual-power method are designed to solving the problem of the traceability of the transmitter and the analyzer of the high voltage and the large current in this paper. The general scheme of the standard power source and the technical scheme of tracing this power source are given, respectively. The I/V converter of precisely measuring the high AC/DC current based on the magnetic modulation method is designed, and the V/V converter of accurately measuring AC/DC voltage based on the principle of resistance series-parallel voltage division is proposed. A test system of variable frequency electric quantity is developed by using LabVIEW and data acquisition card PCI-5922. The comparison experiments of the amplitude and phase shift of the I/V converter (its range is 100, 200, 500 A, respectively) and the V/V converter (its range is 100, 200, 1 000 V, etc.) at 100, 200, 400, 600, 800, 1 000 Hz, are implemented. The experimental results show that the maximum error of the I/V converter’s amplitude is less than 0.02%, and the maximum error of the V/V converter’s amplitude is also less than 0.02%. The accuracy and practicability of the system design is proved.
Keywords: frequency conversion electricity;standard power source;calibration system
2020, 46(5):82-87  收稿日期: 2019-04-04;收到修改稿日期: 2019-07-02
基金项目: 国家质量监督检验检疫总局科技计划项目(2017QK015);湖南省重大专项(2018XK2008);长沙市杰出创新青年培养计划(kq1802025)
作者简介: 柏文琦(1980-),男,湖南永州市人,高级工程师,硕士,研究方向为电磁计量
参考文献
[1] 殷小东, 周峰, 雷民, 等. 基于宽频传感技术的高压电机能效计量检测平台建设及关键技术研究[J]. 电测与仪表, 2014, 51(10): 18-23
[2] 朱岷, 强雄. 国标《变频器供电交流感应电动机确定损耗和效率的特定试验方法》介绍[J]. 电机与控制应用, 2016, 43(12): 96-99
[3] POGLIANO U, TRINCHERA B, LANZILLOTTI M, et al. Characterization of resistive dividers for a wideband power analyzer[C]//Precision Electromagnetic Measurements. IEEE, 2014: 130-131.
[4] 刘博隽, 孙彪, 张甫, 等. 一种频率可调的程控精密恒流源设计[J]. 中国测试, 2018, 44(8): 91-96
[5] 苟轩, 王增增. 高频大电压阻容分压网络的频率特性研究[J]. 中国测试, 2018, 44(12): 152-156
[6] GRUBMULLER M, SCHWEIGHOFER B, WEGLEITER H. Characterization of a resistive voltage divider design forwideband power measurement[C]//IEEE Sensors. IEEE, 2014: 1332-1335.
[7] ROBERT S, CHARLES W, WILLIAM C, et al. Frequency response of thin film chip resistors[C]//CARTS USA 2005. Vishay Thin Film 2160 Liberty Drive Niagara Falls, 2005: 136-141.
[8] 张宣妮, 刘珍, 鲁帆. 电阻分压网络的电感补偿[J]. 中国新技术新产品, 2008(15): 86-87
[9] 刘凛韦, 邓文迪. 基于等效采样的交流毫伏表实现[J]. 传感器与微系统, 2018, 37(10): 92-94
[10] 赵莉华, 牛帅杰, 荣强, 等. 牵引供电系统功率因数计量方法的研究[J]. 电测与仪表, 2016, 53(23): 51-56
[11] 刘金权, 姜会平, 周志辉, 等. 基于两次采样的交直流电功率迭代算法[J]. 电测与仪表, 2016, 53(1): 32-37
[12] 庞吉耀. 一种获得交流信号真有效值方法[J]. 现代电子技术, 2015, 38(13): 53-55
[13] 石照民. 宽频带交流分压器相角偏差溯源方法研究[D]. 长春: 吉林大学, 2019.
[14] 苏璠. 交流电压核查标准研制[J]. 仪表技术, 2019(4): 38-40