作者：李大中, 赵杰

作者单位：华北电力大学自动化系, 河北 保定 071003

关键词：缺陷信号识别;遗传算法;支持向量机;经验模态分解

摘要：

为提高金属探伤时对缺陷的识别能力,提出一种遗传优化支持向量机,结合经验模态分解(EMD),对超声波缺陷信号进行自动识别。首先进行经验模态分解法分解,提取出原始信号特征,构建特征向量。鉴于常用的神经网络模型识别率不高及支持向量机参数难确定的问题,利用遗传算法优化支持向量机模型(GA-SVM)的惩罚因子和核参数,提高支持向量机建模精度。分别采用神经网络模型、SVM模型和GA-SVM模型对特征向量进行训练与测试,GA-SVM模型识别率达到98.437 5%,优于神经网络方法和未改进的交叉验证法SVM模型。试验结果表明:遗传算法能有效提高支持向量机的性能,在小样本条件下能够提高超声缺陷的识别率。

Flaw signal identification in ultrasonic testing based on EMD and GA-SVM

LI Dazhong, ZHAO Jie

Dept of Automation, North China Electric Power University, Baoding 071003, China

Abstract: In order to improve the flaw-recognizing ability in crack detection, a genetic algorithm optimization support vector machine (GA-SVM) has been proposed to identify automatically the ultrasonic defect signals in combination with the empirical model decomposition (EMD). First, the EMD is applied to extract the features of original ultrasonic signals and create feature vectors. Considering that common neural network models are low in recognition rate the SVM parameters are difficult to determine, the penalty factor and kernel parameter of the GA-SVM were employed to enhance the modeling precision of the GA-SVM. The feature vectors are trained and tested with the neural network model, SVM model and GA-SVM model. The recognition rate of the GA-SVM model is up to 98.437 5%, higher than the neural network model and the unimproved cross validation SVM model. Experimental results show that genetic algorithm can improve SVM performance. This machine can increase the recognition rate of ultrasonic defects in small samples.

Keywords: flaw signal recognition;genetic algorithm;SVM;EMD

2016, 42(1): 102-106  收稿日期: 2015-05-18;收到修改稿日期: 2015-06-27

基金项目: 

作者简介: 李大中(1961-),男,内蒙古包头市人,教授,博士,研究方向为新能源发电系统控制、智能优化理论及应用、分布式新能源发电及冷电联产控制系统。

参考文献

[1] 姚凯. 基于金属磁记忆法的铁磁材料早期损伤检测与评价的实验研究[D]. 北京:北京交通大学,2014.
[2] 白冬莆,崔书赫,张娉婷. 超声波探伤检测的影响因素分析及监督与控制[J]. 硅谷,2014(5):71-71.
[3] 杨川. 焊缝缺陷图像特征提取研究[D]. 武汉:武汉理工大学,2010.
[4] 都衡,潘宏侠. 基于局域波信息熵的高速自动机故障诊断[J]. 中国测试,2014,40(1):115-118.
[5] 李娟,杨录,张艳花. 基于EMD与欧氏距离的缺陷信号识别方法[J]. 山西电子技术,2011,33(2):35-36.
[6] 阮晴,罗飞路,王鹏. 基于BP网络和D-S证据理论的超声检测缺陷识别[J]. 兵工自动化,2011,30(9):72-76.
[7] 刘清坤,阙沛文,郭华伟,等. 基于支持向量机和特征选择的超声缺陷识别方法研究[J].中国机械工程,2006,17(1):9-12.
[8] HUANG N E,SHEN Z,LONG S R,et al. The empirical mode decomposition and the hilbert spectrum for nonlinear and non-stationary time series analysis[J]. Proc R Soc Lond,1998(454):903-995.
[9] 韩文虹,高淑婷. SOM离散化和IGA优化神经网络传感器故障诊断[J]. 中国测试,2014,40(5):88-91.
[10] 王春龙,刘建国,赵南京,等. 基于支持向量机回归的水体重金属激光诱导击穿光谱定量分析研究[J]. 光学学报,2013(3):307-312.