您好,欢迎来到中国测试科技资讯平台!

首页> 《中国测试》期刊 >本期导读>动圈式检波器的测试标定方法研究

动圈式检波器的测试标定方法研究

2672    2016-04-29

免费

全文售价

作者:张帅帅, 林君, 张林行, 徐立安, 孙副津, 杜赫然

作者单位:吉林大学仪器科学与电气工程学院, 吉林 长春 130061


关键词:地震检波器;特性参数;正弦扫频电激励;频率响应


摘要:

依据动圈式地震检波器的互易性质,将检波器的电气特性与力学特性相结合,提出用正弦扫频激励代替传统的振动台激励来测试标定动圈式检波器特性参数的新方法。在深入分析动圈式检波器的结构、工作原理及性能特性的基础上,建立这一方法的数学模型,推导出正弦扫频激励下检波器频率响应的表达式,并得出6参数模型,然后以此为目标函数,对实测频率响应函数进行曲线拟合从而确定检波器的特性参数。理论分析及实测结果均表明:此方法稳定性好、准确度高、测试系统简单,适合检波器生产、维修、施工检测及标定使用。


Design and calibration of moving-coin geophone

ZHANG Shuaishuai, LIN Jun, ZHANG Linhang, XU Li'an, SUN Fujin, DU Heran

College of Instrumentation and Electrical Engineering, Jilin University, Changchun 130061, China

Abstract: Taking both electrical properties and mechanical properties of geophone into consideration, and according to the essential property-reciprocity, a new method for measuring and identifying characteristic parameters of moving-coin geophone was proposed, where sine sweeping signal was considered as the electric excitation instead of the traditional vibrational excitation. After thoroughly analyzing the working principle and performance characteristic of 6-parameters is obtained. Using the expression as the objective function to fit the measured amplitude-frequency curve, geophone's characteristic parameters are then obtained. Finally, verification test is performed and factors affecting measure accuracy are analyzed. The theoretical and experimental results indicate that the presented method is suitable for production and maintenance, especially for in-situ calibration of the geophone due to its easy operation, high accuracy and good stability.

Keywords: geophone;characteristic parameter;electric sine sweeping exciting;frequency response

2016, 42(4): 25-28  收稿日期: 2015-10-06;收到修改稿日期: 2015-11-25

基金项目: 国家深部探测专项(201011081)

作者简介: 张帅帅(1988-),男,山东济宁市人,硕士研究生,专业方向为分布式地震仪研制及自动化与智能控制。

参考文献

[1] 陆基孟,王永刚. 地震勘探原理[M]. 北京:中国石油大学出版社,2009:65-70.
[2] 石金成,付小宁,冯旭东,等. 直流激励法测量地震检波器的原理和溯源[J]. 石油工业技术监督,1999,15(3):10-11.
[3] 罗兰兵. 陆地地震检波器应用研究[D]. 长春:吉林大学,2005.
[4] 付小宁,严正国. 动圈式地震检波器阻尼系数测量方法的改进[J]. 计量技术,1999(8):21-22.
[5] 张奇文. 磁电式地震检波器动态特性测试方法研究[D].大庆:大庆石油学院,2008.
[6] 张改慧,胡时岳. 地震检波器特性参数识别的一种新的正弦扫频恒流激励方法[J]. 应用力学学报,2006,23(3):427-431.
[7] 付小宁,石金成,严正国. 最小二乘法估计地震检波器的参数[J]. 传感器技术,1999,18(2):51-52.
[8] 方兵. 动圈式地震检波器性能优化研究[D]. 长春:吉林大学,2009.
[9] 李海清. 电动式地震检波器悬体质量对其性能参数的影响[J]. 物探装备,2003,13(3):159-163.
[10] 俞阿龙,黄惟一. 振动速度传感器幅频特性改进方法的研究[J]. 自动化仪表,2004,3(4):289-291.
[11] 徐静,曾志新,刘桂雄. 提高传感器动态特性方法分析[J].机电工程技术,2002,31(5):25-27.